Articles in this section

See more

[Guide] Install Diagnostics - CO2 Pressure Not Detected

  • Updated
WARNING
HAZARDOUS VOLTAGE (120V)
CONTACT MAY CAUSE ELECTRICAL SHOCK AND INJURY. 
DISCONNECT POWER BEFORE SERVICING.

  1. Remove the top panel from the back of the Bevi.

    • Loosen the 6 screws in the corners of the panel.
    • Lift the panel up to unhook from the screws, and remove.
    • Place the panel to the side.

  1. Remove the center panel from the back of the Bevi. 

    • Loosen the 4 screws in the corners of the panel.
    • Lift the panel up to unhook from the screws, and remove.
    • Place the panel to the side.

  1. Locate and Inspect the CO2 Sense connection.

    • The CO2 Sense connector is at the bottom, far right side of the BUC Board.
    • Verify that the connector is fully seated in the BUC Board. 

  • Visually inspect the connector and wires for any damage along the entire cable between the BUC Board and the CO2 pressure sensor.  

  • Carefully disconnect, and reconnect the CO2 Sense cable.
    • Ensure the cable fully clicks into the connector on the BUC Board. 

 

  1. Repeat the Diagnostic Test

    • If the test passes, continue with Installation.  
    • If the test continues to fail, please contact Bevi Support at 866-704-2384