Troubleshooting
This section will help you diagnose any issues you might find with the Bevi Standup 2.0
- [Machine Alert] Water Pressure Sensor Disconnected
- [Alerts] Filter Out (SU2.0)
- [Guide] Install Diagnostics - Buffer Tank Pressure Too Low/Not Connected, or Too High
- [Guide] Install Diagnostics - Base Leak Detected/Float Switch Disconnected
- [Guide] Install Diagnostics - Flavor Sense Error (Slots 1-8)
- [Guide] Install Diagnostics - Ice Bank Temp Too Low/Not Connected
- [Guide] Install Diagnostics - Power Supply Voltage Too Low/High
- [Guide] Install Diagnostics - ADA Board Not Detected
- [Guide] Install Diagnostics - LED Board Not Detected
- [Guide] Install Diagnostics - Chiller Fan Current Too Low/Not Connected, or Too High
- [Guide] Install Diagnostics - Demand Pump Current Too Low/Not Connected, or Too High
- [Guide] Install Diagnostics - CO2 Pressure Not Detected
- [Guide] Install Diagnostics - Heater Temp Not Detected
- [Guide] Install Diagnostics - Board Not Detected (DCB, PDB, BUC)
- [Guide] Install Diagnostics - Heater Current Too Low/Not Connected, or Too High
- [Guide] Install Diagnostics - Chiller Compressor Current Too Low/Not Connected, or Too High
- [Alert] Significant Low Pressure (Standup 2.0)
- Machine Alert - Inlet Water Temporarily Unavailable / Inlet Water Unavailable
- Machine Alert - Chiller Electrical Issue
- Standup 2.0 Troubleshooting Summary
- [WEBINAR] Standup 2.0 Troubleshooting Nozzle leaks or CO2 leaks
- Troubleshooting CO2 Early Run-Out or Leaks on Standup 2.0
- [Guide] Sparkling Purge Failure Standup 2.0
- Bevi Alert Center - Suspected Faulty Touchscreen
- Standup 2.0 Cloudy Water Troubleshooting [SOP]
- Troubleshooting Nozzle Drips on The Standup 2.0
- Bevi Alert Center - Chiller Not Cooling
- Machine Alert - Frozen Chiller in a Bevi Standup 2.0
- How to prepare a Bevi Standup 2.0 for shipment to another location
- Bevi Standup 2.0 Alert Center - Ice Bank Low