Installation & Product Specs
- SU 2.0 Spec Sheet and Dimensions
- Certifications and Compliance (SU 2.0)
- Pre-Install Requirements - Standup 2.0
- Standup 2.0 Install Guide (120 V, US/North America)
- Standup 2.0 Install Guide (240 V, UK/Europe)
- ADA Design Statement - Bevi Policy for the Bevi Standup 2.0
Replenishment and Maintenance
Features & Operation
Removing and Replacing Parts
- Replace Buffer Tank Guide and Alert, Standup 2.0
- Upgrading Gen 1 to Gen 2 Touchscreen & SBC Kit, SU 2.0
- SU 2.0 Gen 2 Touchscreen Remove & Replace Guide (NA Gen 2 and UK/EU)
- SU 2.0 Gen 2 CO2 Regulator Remove & Replace Guide (NA and UK/EU)
- SU 2.0 Gen 2 Chiller - Removal and Replacement Guide (NA and UK/EU)
- SU 2.0 Gen 2 Single Board Computer (SBC) Remove & Replace Guide (NA and UK/EU)
Troubleshooting
- Standup 2.0 Troubleshooting Summary
- Troubleshooting CO2 Early Run-Out or Leaks on Standup 2.0
- Standup 2.0 Cloudy Water Troubleshooting [SOP]
- Troubleshooting Nozzle Drips on The Standup 2.0
- [Guide] Troubleshooting Low or No Flow of water when dispensing from The Standup 2.0
- [Guide] Sparkling Purge Failure Standup 2.0
Troubleshooting Machine Alerts
- [Alert] Excessive Heater Temperature Detected, Standup 2.0
- [Machine Alert] Water Pressure Sensor Disconnected
- Machine Alert - Inlet Water Temporarily Unavailable / Inlet Water Unavailable
- (Alert) Standup 2.0 - Chiller Electrical Issue
- Bevi Alert Center - Suspected Faulty Touchscreen
- Bevi Alert Center - Chiller Not Cooling
Install Diagnostic Errors & Troubleshooting
- Standup 2.0 Install Diagnostics - Error Messages Index
- SU 2.0 Install Diagnostics - Board Not Detected (DCB, PDB, BUC)
- SU 2.0 Install Diagnostics - Power Supply Voltage Too Low/High
- SU 2.0 Install Diagnostics - Ice Bank Temp Too Low/Not Connected
- SU 2.0 Install Diagnostics - Heater Temp Not Detected
- SU 2.0 Install Diagnostics - Buffer Tank Pressure Too Low/Not Connected, or Too High