Skip to main content
Bevi Partner Resource Center Help Center home page
  • Submit a request
  • Sign in
  • Sign in
  • Submit a request
  1. Bevi Partner Resource Center
  2. Standup 2.0
  3. Removing and Replacing Parts

Removing and Replacing Parts

This section will hold documentation on how to remove components of the Bevi Standup 2.0 that may need to be replaced.

  • Bevi Standup 2.0 Remove and Replace - Door Board (Restock/BIB Scanning Board)
  • Chiller float switch remove and replace [Guide]
  • Installing The Standup 2.0 Drain Kit
  • SU 2.0 (Gen 1) Chiller Remove & Replacement Guide
  • SU 2.0 Gen 1 Single Board Computer (SBC) Remove & Replace
  • SU 2.0 Gen 1 Touchscreen Remove & Replace Guide (US/NA)
  • SU 2.0 Gen 2 CO2 Regulator Remove & Replace Guide (NA and UK/EU)
  • SU 2.0 Gen 2 Single Board Computer (SBC) Remove & Replace Guide (NA and UK/EU)
  • SU 2.0 Gen 2 Touchscreen Remove & Replace Guide (NA Gen 2 and UK/EU)
  • SU 2.0 Recirc Pump Assembly (Chiller Agitator) Replacement in Gen 1 Chiller
  • [Guide] Bevi Standup 2.0 Removal and Replacement Guide - Manifold 1
  • [Guide] Bevi Standup 2.0 Removal and Replacement Guide - Manifold 2
  • [Guide] Bevi Standup 2.0 - Removal and Replacement - Manifold 3
  • [Guide] Bevi Standup 2.0 - Remove & Replace Buffer Tank
  • [Guide] Bevi Standup 2.0 Power Module Removal and Replacement
  • [Guide] Bevi Standup 2.0 Remove and Replacement - Demand Pump
  • [Guide] Hot Water Tube Installation on The Standup 2.0
  • [Guide] Standup 2.0 Heater - Remove and Replacement
  • [Guide] Standup 2.0 Remove and Replace - Base Unit Control Board (BUCB)
Bevi Partner Resource Center