Before Continuing
During the Install Diagnostics test, the filter should not be installed, and water and CO2 should not yet be turned on. If these steps have already been done:
- Turn off water supply
- Turn off the CO2 tank by rotating the handle clockwise until it stops.
- Remove the filter.
- Drain the Buffer tank.
Troubleshooting
Task 1: Repeat the Diagnostic Test
- Verify water and CO2 are turned off, and filter is NOT installed.
- Restart the diagnostic tests to see if it passes on the second attempt.
- If the test continues to fail, power cycle the Bevi via the power switch on the front of the chiller.
- Navigate back through the installation steps to the Install Diagnostic step and repeat the test.
- If the test continues to fail, this may indicate an issue with the BUC Board and will need to be replaced.
- Please contact Bevi Support at 866-704-2384.