BiB Connector Fitting Remove & Replace, CT 2.0 Head Unit

Overview

This guide provides a step-by-step process of swapping a BiB connector fitting in a Countertop 2.0 head unit’s flavor line.

In this article (click to jump):

• Required Tools & Parts
• Remove and Replace Procedure
  • Task 1: Power Off the Bevi
  • Task 2: Disconnect the Flavor Box
  • Task 3: Remove the Old Fitting
  • Task 4: Replace the Fitting
  • Task 5: Prime the Flavor Line

Required Tools & Parts

• 720-0394 - FRU - FLAVOR LINE BIB TO PUMP
• Tube cutter
• Box cutter

Remove and Replace Procedure

Task 1: Power Off the Bevi

1. Power off the Bevi using the power switch on the front of the chiller.
2. Disconnect the power cord from the back of the chiller.

Task 2: Disconnect the Flavor Box

1. Open the cabinet and locate the flavor box that corresponds to the fitting that is being replaced.
2. Turn the threaded connector counter clockwise to disconnect from the box.

Task 3: Remove the Old Fitting

1. Remove the fitting from the BiB connector.
   1. Depress the push-to-connect fitting on the threaded BiB connector.
   2. Pull on the fitting with the push-to-connect depressed to remove it from the BiB connector.
2. Set the threaded BiB connector to the side.
3. Use the tube cutters to cut the flavor line slightly above the BiB connector fitting.
   1. Ensure the cut is made on the flavor line above the fitting.
   2. Take care not to remove too much flavor line from the head unit.
4. Dispose of the old BiB connector fitting.

Task 4: Replace the Fitting

1. Remove the flavor line from the new fitting.
   1. The FRU contains both a flavor line and the fitting.
   2. Use a box cutter to cut the flavor line away from the new fitting.
   3. Take care not to cut into the new fitting.
2. Insert the new fitting into the flavor line using a twisting and pushing motion.
   1. Ensure the flavor line is fully seated on the new fitting.
3. Insert the fitting into the threaded BiB connector.
   1. Ensure the fitting is fully seated in the push-to-connect fitting in the threaded BiB connector.
   2. Use the groove on the fitting to gauge if it is fully seated in the connector.

Task 5: Prime the Flavor Line

1. Reinstall the flavor connector onto the flavor box.
   1. Turn the threaded connector clockwise until it is hand tight.
   2. Ensure the connector is seated flush.
2. Plug in the power cord and power on the Bevi.
3. Navigate to the Service Panel.
   1. Touch the service icon in the upper left corner.
   2. Touch "Start Service"
   3. Enter the PIN to access the service panel.

4. Navigate to Troubleshooting Tools
   1. Touch the ‘Alerts and Maintenance’ button.
   2. Touch the ‘Troubleshooting Tools’ button.

5. Touch the ‘Flavors and Enhancements’ menu.
   1. A drop down menu will open up.
   2. Identify the flavor pump to be primed.
6. Hold a container directly under the nozzle.
   1. When priming, only flavor concentrate is dispensed.
   2. Flavor may come out at an angle.
7. Press the relevant button to prime the flavor line.
   1. Allow the prime cycle to run all the way through.

8. If no flavor is dispensed:
   1. Double check the connection between the flavor box and the threaded connector.
   2. Confirm you can hear the pump running.
   3. Double check the tubing connections on the pump, if they are reversed flavor will not dispense.